On the 2 jeeps I've built, a 75 and just finished a 80, I need thoughts on ride height. Both have the rough country 2.5 inch kits with greasable...
Got my engine broke in other day and trying to fine tune it. I can't get it to idle below 1000rpm. Cam is comp 268, edelbrock preformer intake and...
This is actually a 80 cj5 but basically the same as the intermediate as far as the fuel system. Some experts here so here it goes. Just installed...
Which top would you guys recomend? Going with a Besttop and undecided on the tigertop of the supertop. Whats the pros and cons of eadh
Just installed a fuel pressure regulator this morning to make sure I'm under the 6.5 psi edelEdelb recomends. I'm still running rich. Timings set...
Back to the experts! Finally got to take a few longer drives yesterday. Got side pipes put on and can hear more now that it's not straight...
Thanks for all the help so far. Very knowledgeable and helpful group of folks here. Got my brakes working good and went for the first ride today....
I'm done with the Jeep and ready to take a test drive but have no brakes. I replaced everything in the brake system. Proportional valve is...
Trying to finish this project up in the next few weeks. When I got the jeep it wasn't running. Pulled the motor to rebuild and everything is new...
Getting close to finishing up my rebuild. Can't seem to find the following Grommets that go in dash glove box Side aluminum rocker moldings. Don't...
I'm having a very dificdiff time with this. I bought a generic 12 circuit hotrod harness for my 75 cj5. I've got everything working except for the...
Anybody know where to find? I've found all other stainless hardware but can't find the windshield hinges. Also I've found are 76 and up.
Been working a 75 cj5 for about a month now. Got it stripped and sandblasted, frame painted and tub primed. Almost got the rolling chassis ready...
Separate names with a comma.