No we ended up jamming it upfront but the front made friends and destroyed it. So either going to get a custom one made and pull the front axle...
Well another long over due update. The jeep is done for now and my little brother is enjoying it! He’s put close to 1000 road miles and it cruises...
Long time, No post but the build is still moving and about to pick up the pace rapidly as I have a car show in 2 weeks to make it to! Jeep made...
There’s simply no room for it to be tilted sadly. Trying to find a fan and shroud combo under 3 inches thick at the moment. If I switch to...
Also here’s some pictures of the seat mount we made and swing pedals. All the pedals will be on one side of the steering column to make it easier...
Got to fiddle some more this weekend. Got almost all the front suspension final welded, cut out the old crossmember that’s in the engine bay and...
Just realized I watched all your videos before going with the ls power plant. I never thought about using AN lines for power steering and clutch,...
As of right now the radiator I have will fit in the gap with about an inch to spare. But that’s with the big bulky headlights out going to get...
Small update rolled the old girl out of the garage to clean and stand back to look at everything. Most of the suspension is final welded, added...
This one is a 69. V8 is definitely tight but I cut the grill apart and shoved the motor back. With the rear axles pushed back still have plenty of...
I just relocated to the tawas/Oscoda area
I am in Michigan Sbc bell housings are the same except for the top bolt. I had this motor in my tj but with a th350 and beat on it for years...
Im using rear spring for a 2a up front, I see I left that part out. Theyre 40"s long so a bit longer then a cj5 front spring and should run about...
71BBF647-AEE4-4E24-B10E-39603DAB869C by JeepinLee posted Nov 2, 2022 at 7:30 AM B3ECE591-BC8C-4CF3-A4F3-F17ECABDBA6F by JeepinLee posted Nov 2,...
Finally started to build my 50 dollar cj so figured I’d make a thread if anyone is interested in following. current plan for everything: All...
Thanks for the reply’s guys! I plan on pulling it apart and seeing if I can find any part number but was just curious if anyone has done this swap...
Hey everyone, not sure this is the right thread, apologizes if it is. I recently picked up a parts Jeep to build my 69. Has all the goodies like a...
You can always put a inline valve that holds pressure to the rear brakes. Plenty of people use them in the off road world. A guy in a club with a...
Separate names with a comma.