Make sure you use GL-1 or GL-4 safe for yellow metal gear oil and fill it as full as you can get it.
SO curious the 1970 model year was AMC not Kaiser. My dads bought new early (had the Rhino grill) 1970 J3000 was badged AMC Buick 350. This jeep...
Back in the day when my dad was competing in Jeep Jamborees the rule for roll bar height was it had to be 2.5" taller then the driver when wearing...
My D44 is a 30 spline flanged used 1970-71 and I sure don't remember anything like the backing plate holding the bearing in. In fact I sure of it...
The most likely reason for there to be no serial number on the engine is that the block has been decked a few thousands during a rebuild. My block...
I would suggest if putting a Holley FI unit on a 134 of either stripe you put in on a 1/2" thick Phenolic Heat spacer to help keep the electronics...
CHUG is a collection of parts from as far as I know 28 different jeeps from 1946 to 1972 all civilian. When dad bought it in 1962 it was a 48...
E-10 is as the name implies is 10% Ethanol. Ethanol has 60% of the BTU's of gasoline so your loosing 4% of total energy compared to the same...
Some reality check for you. The HP numbers posted for Willys engines are bare engines running on a engine stand type dyno with the HP rating...
The top is a structured insulated thing I have been building the last couple winters. I hope to have it painted this 4th of July weekend. I could...
I went with Two UL rated 1-A,10-B:C U.S.C.G, DOT approved Kiddie Extinguishers Mounted on QR brackets I made on either Roll bar up right. This...
Cole-Hersee makes some very high quality ignition switches. https://www.littelfuse.com/products/switches/ignition-switches.aspx I chose one of...
No need for all that. When I park I pull out the hand brake I reach the hidden fuel pump switch and I knock the Hi Low into neutral As I walk...
LOL SW has been made in Mexico since 1984 Their quality is the same as its always been I have used them since my first vehicle in 1977 a 57 Wagon...
SAFCO same liability as on the car and pickup with agreed value of $20,000 on my 2A has to be garaged at night. 10,000 mile limit per year. O...
Electric fuel pump with kill switch. If the jeep has been run recently it will not get you out of a grocery store parking lot before it dies....
I have used Summit, Fargola, Earls Areoquip and Russell brand fittings all mixed up. I use the Summit brand Nylon Braided hose (the Black and Red)...
I have a Craftsman rotary tool very similar to a Dremel I also have two Dremels. I have used the things for all manner of work. I also have a die...
Where's the plate from the one on the pickup looks kind like a colorado plate
The front shocks are in a different position on the 3A frame the early jeeps the shocks were straight up and down in the 3A chassis they angled...
Separate names with a comma.