I've been struggling with my LUK 01029 not disengaging on a 68 cj5 V6. This kit seems to work for some, but many have had issues, it seems. I...
Thank you!
That's a great idea....it is a bitch to use the orig set up.
Looks nice! I used some heat and bent mine to fit. Can anyone share pics of the bumpers?
I used blackpipe and went across the tub with a support in the middle. More or less same as orig, I think. The existing set looked like they had...
Did you try Kaiserwillies? kaiserwillys.com. I haven't used them for paint but they have a lot of orig colors in the catalog. I agree, paint is...
Very sorry to hear of your loss.I am sure this is a very difficult time. It is a beautiful Jeep, your in the right place to find someone who will...
Hi, I was wondering if you installed the wireing harness yet? If so how did it go? I'm. Lokking for one for my 68 cj5. I bought a cheap one and...
Hmmmm, I didn't think about the shocks being to long. I just put a 2.5" procomp lift kit on my 68. I will measure the fully compressed spring pin...
Personally I think inside is a better option as its protected from the elements. If there is an issue, i.e. short that causes a fire you'd be more...
This is helpful...thanks for the photos!
Thanks for the info Colojeepguy! So... it sounds like I should be using oil with Zinc like VR1 for older motors...correct?
I just got mine back from the machine shop and was told to use Lucas break-in oil (I think that's what I got) with zinc additive. New oils don't...
You make a good point, pick something you like....I think thats what I will do. Thanks all!
Thanks! I will look for him.
Do you have a number or address for the guy in MA?
That looks great! I'm looking for paint for 68, the original was a metalic green, the forum seemed to settle on Alpine Green, overed a few cans on...
Hi, thanks for your suggestion. It didn't look like there was a burr on the shaft, but I will take another look and try that. If that doesn't seem...
Oh geez....well you passed the test! One of us was paying attention......yes, its a large bore D18. Both were rebuilt.
Hi, looking for help. I rebuilt my 68 T14 and reused the original output shafts. The front yoke was installed fine, the rear yoke (original) will...
Separate names with a comma.