So tonight I took the whole cluster out of the Jeep. I took the cluster apart and hooked the fuel gage up independent of the cluster and I was...
Thanks for the replies, I started pulling the gage cluster out last night and should be able to finish tonight. I think that Howard is correct...
So I tried the ground from the ground on the battery and same thing. Gage act strange if I ground the S wire it only goes to the same spot and...
This is a repo gage from Kaiser Willys. Here is what they say Empty- 1/2 Tank- Full Tank- 73 ohms 23 ohms 10 ohms
Good afternoon all So I am close to finishing up my 57 CJ5 project and I have everything working except the fuel gage? I have read a lot of the...
Thanks it has and continues to be fun. Marty
All, I wanted to reach out an thank all of you for the post to me or on other issues that I needed to work on. I wanted to share a picture after I...
So just an update, I went out tonight and changed the points out and put in the Pertronix 1548 in my 60 CJ5. Took about 30 min and than I...
Thanks. I plan to change out the points tonight and add electronic ignition. With that I will have a new coil, new plugs and wires. I will post...
If it still is not running correctly Marty
All, I am attempting to get my 60 CJ5 running under load and have a few questions. Problem: it will start right up but wants to stall when you...
Here is the YouTube Thunderhead289 How to: test any engine ignition coil - simple & effective (not for current subscribers) if you just copy...
Nice, I was getting spark but not enough so $30 and I’m running again. I still plan to change out the old points, condenser, rotor and cap but...
Ok so just an update, I received the new cap and rotor today, started with a new rotor no luck so I went with the rotor and cap still no luck....
It was by rolling the engine and yes I am asking a friend to take a look. Thanks new cap will be here on Monday. marty
I went out and I have good spark from the coil wire when I put a spark plug in the coil wire. I did find out something that may be the problem....
I will try that tomorrow, thank you Marty
So just an update, I got anew rotor and changed out the distributor cap. Still no spark to the plug wires. I jumped a wire from the battier to...
So just a question, does it make a difference if I just turn the key to the on position (using a remote start) to check for spark in the wires or...
Thanks, I went thru and cleaned my grounds just in case. I will make sure not to leave the ignition on while I’m working. I have a tester and...
Separate names with a comma.