https://www.carscoops.com/2022/10/kilows-minimalist-jeep-willys-aping-ev-is-meant-for-urban-and-off-road-adventures/amp/ A bit fugly, but this...
I’m trying to install 11” brakes on the rear of my 1956, and am running into an issue making the final connection from the existing 9” brake hard...
I may be totally overthinking this… I know people talk about priming the oil on new engines builds before the first start up, but what about an...
My FSM shows different brakes than I actually have, so I’m not sure what the correct shoe orientation is supposed to be. My brakes aren’t self...
I have a 1956 cj with a 198 Buick engine. The PO had installed an ancient aftermarket remote oil filter with very narrow hoses and a roll of...
I have a leaking wheel cylinder and am trying to remove my rear brake drum. 9” drums. They look to be aftermarket, as they have the three screws...
I drove the Jeep downtown today. Was parked for about 5 minutes and when I tried to restart, it sounded like the starter was turning but the...
About a year ago, a guy contacted me through the nextdoor app, asking if I could weld him a new grate for his BBQ. Well just today, he texts me...
I’m hoping someone can give me some measurements from their spare tire carrier. The one that normally mounts on the passenger side rear fender....
I’m looking to get a softer ride, and figured i would try removing a leaf from the front and rear spring packs. They’re rancho 2.5” lift springs,...
I finally got around to wiring up my fuel gauge. It’s a stand alone 2” gauge. Brand is equus. Sender is brand new. Crown or omix, i can’t...
[ATTACH] [ATTACH] sorry the first pic is upsidedown. I have a Saginaw conversion and the tierod and drag link are currently parallel with each...
Can anyone confirm if these are the correct timing marks for a 198 oddfire? Sorry for the extreme close up, but for perspective these markings...
I have a 198 and it’s very hard to start when cold. Doesn’t sound like it’s cranking as fast as it should. Battery is a brand new Delco AGM 760...
[ATTACH] I was looking to make my own lifting shackle brackets similar to the M38A1, and was curious if anyone knows the approximate dimensions:...
[ATTACH] [ATTACH] I just replaced the fluid in my transfer case and after driving it, there is a leak out of a threaded hole in the advance...
[ATTACH] [ATTACH] My power steering pressure hose recently developed a leak in the rubber section right before the metal crimp. this is an...
[ATTACH] Here are some specifics on my Jeep: 1956 CJ5 with rancho springs (approximate 2” lift, I believe) “Stock” 16” wheels that are pretty...
[ATTACH] Looking for a little help here, as I’m clearly doing something wrong. I have a 2G in a 198 Buick oddfire. Chart says float level of...
[ATTACH] [ATTACH] [ATTACH] I got a set of four of these wheels when I bought my cj. I’d like to get a 5th one, but not sure exactly what they...
Separate names with a comma.