I have a 7 blade aluminum blade cooling fan not stock. My clutch fan has play and makes noise. I was looking into a 2797 haden severe duty clutch...
that is the picture I needed thank you
I bought the only release cable sold. I think for a 76 others said its too long but just need to loop it. I can build the bracket did it mount on...
[ATTACH] I bought a new release cable for 76 cj5 I know it is different but I think I am missing the mounting bracket for the TEE handle 8.180-13...
my 74 did the same. then started working again but speed is still off. I left it alone after searching for gears not found.
same happened to me I just cut a section of the old seal and filled the gap with that. its like you wont know the final size so I would say cut it...
ordered the cable will let you guys know how the 1972 cable works
Crown Automotive Parking Brake Release Cable - J5350541 is this the proper cable to fit my 74 cj5? HERE IS A SCREEN SHOT OF THE CABLE [ATTACH]
I bought the willys temp gauge cheap it works good but had to add a adaptor and had to install a small led light inside the gauge. saved a few...
THE proper carb is a 108 right now i have a holley 650 vac secondary and de tuning it to work with 74 304 v8 it has a cam in it long tube headers...
Due to the new gas with the boiling point lower now, how many of you guys added a fuel return line to your 74 cj5 304. During the intake upgrade...
transition ports on carb check into that. the amount of port exposed by the butterflys. on holley it can be adjusted on the 4 barrel side by the...
had to buy the 3/8 temp sender bushing from parts store, removed the thermo vac switch in intake installed the probe their. have not ran it yet...
You are correct the novis plastic polish comes in different grits. the heavy scratch green label and the regular red label. also at the bus garage...
way back in 1979 my buddy fixed mine with novis plastic polish found at fish store for plastic tanks
Glad you guys post this info, I ordered a mech temp gauge for a willys jeep to fit to my 74 amc 304. it was cheep for a mech gauge. The only...
It seems the factory splice had something to do with the headlight switch overheating on my 74 too. Last night was studying the wire diagram wire...
25 years ago my fuseable link melted down in wire harness then repaired. Latley i found the connection of headlights wires and ammeter wires all...
Voltage drops can be measured across the starting system. Heat=resistance. Resistance values =.2 volts per connection and .2 volts for the cable ....
Dwell is the measurement the time points are closed. So a dual point system can build higher spark by splitting the time in half.. if I have that...
Separate names with a comma.