Depends on the cooling system. Some have a closed system with antifreeze and an inter cooler. As long as the zinc diode is in good shape it...
Boats with single drives are standard rotation from factory. With twin drives the port motor is reverse.
Sounds like a good recipe. I bet it doesn’t leak from the repair. My experience of the dana 18 is that it’s just like a Harley. if it isn’t...
I picked a wrangler pitman arm. Between flipping the tie rods and the 2” drop in the arm it should be really close to perfect. I also think the...
Most of the parts I used came from AA. Gear box from a J10 truck. Column is a GM clone. I hate chrome but it was scratched and got it for half...
Muriatic acid then a small amount of liquid chloride or organic flux and you can silver solder cast iron with high confidence
On my long list of things that need attention, full float locking rear is coming up. I have an open 3.73 one piece axle rear end. Would a guy be...
Yes. I cut the radiator mounts off of the core support (to match the angle of the fan) then bolted 1 1/2” x 3/16” bar to radiator. Mocked it in...
Had some extra heim joints from another project laying around so I picked up some 5/16” cold rolled stock and beefed up the core support rods....
Haha! I’ve got tons of photos. I’ll go re read the posts on adding photos. But it might be a “permissions” thing. When I click on photos I get an...
I work on a party boat in morro bay. Look for my Jeep in front of giovanis once the season starts
I followed the steps provided in the sticky thread from sparky. Can you not see the photo?
IMG_5057 by Play Dead posted Feb 24, 2024 at 5:54 PM I drove it! Thanks to all the members on this board for your knowledge and passion! It...
I figured it was too good to be true.
https://losangeles.craigslist.org/wst/ctd/d/monterey-1969-jeep-cj-tuxedo-park/7714799061.html
Jeep has 11” drums at 4 corners and a slick clutch linkage (the only good thing bubba did) I have made a throttle linkage and pedal so hanging...
I have a 71 cj5 that I am converting to Saginaw power steering. My most recent issue is figuring out how to mount my 2” diameter flaming river...
I would run a rubber “nipple” right after pump or right before carb. I like having a little wiggle in the fuel line. But I don’t like how it...
My father in law carries sawdust in a ziplock in his hunting rig. Swears it will patch pinholes in the cooling system.
I use a cheap electrostatic setup ($200 IIRC) for coating anything metal. You don’t need the expensive paint if you have access to old school oil...
Separate names with a comma.