I debated on chiming into this discussion, but what the hell, I haven't been castigated in a while... Howell EFI - I put one of these on a 350...
I've probably done 30 if these in the last 4 decades, most before kits were common, and the conversion is not that hard if you can weld. I used...
The last few speedi sleeves I prices were so expensive I just spent a few extra dollars and bought a new yoke.
I tried these mufflers, and unless you have a full length exhaust, the sound was load and unpleasant. They now live in the second floor of the...
:shock:
I used a Genright steering kit with 5/8 hiem joints and flipped the tie rod at the same time. Once I built the tie rod and drag link, I used a...
I used a radiator for a 1965 mustang with a 289 V8 for my cj2a truck conversion with a Buick 231. I spent about $189 2 years ago, no telling what...
Herm is a good dude, but very, very slow to respond and ship parts, but He has a lot of knowledge and parts. I've waited 6 months for parts to...
I run an sm420 in my cj2a truck conversion, and it's a solid transmission...no slop. That first gear is so low it's unreal. I have a 93:1 crawl...
I have a Buick V6 and SM420 which I have had in and out several times, and I always pull the transfer case first and then the engine/ transmission...
Nice jeep!
I like the banjo fitting, wish I would have used one. I have a great hydraulic hose shop locally, and they made me a short 90 degree pipe with...
I've owned a lot of jeeps and I've done a lot of motor swaps, both Buick V6 and Chevy V8 and I even had a cj5 with a stock odd fire 225 V6, and I...
Dana 44 isn't hard to rebuild, but you will need some tools if you are going to replace all bearings and seals: - dial indicator - press - slide...
With my sm420 transmission and 5:38 gears, my first gear, low range is 93:1, and I still wish I had a lower gear on some of the trails in Moab...
Welcome. Lot's of guys with a ton of knowledge here...
At the end of the day, we own the cost of our own repairs, so hold no grudge to those who decide to mix their own, us 90 weight gear oil to just...
If the original axle shafts with the Rzeppa joints have been replaced with 1310 ujoint shafts, the type of grease is less of an issue, but those...
I use synthetic on my 2014 Rubicon, as it sees standard off-road recovery...mostly of other rigs. I have about 130 winch pulls on the warn and I...
Flat towing without lube will definitely cause issues...
Separate names with a comma.