Jackdog, spent a couple hours today and replaced the front axle shims. Upon inspection, I had the 2 deg shims that came with my 4" lift kit in...
Curious what you find, my commando wanders at speed also. I've replaced the saginaw box, springs, lower and upper steering shafts, tie rod ends....
Is there a better Housing Cap for the Tremec T176 than the Crown part # J8134667? I would rather something machined or forged, the stamped steel...
Question, does the Lower Steering Shaft (Part # 999-714) for a 1973 C104 Jeep Commando with Power Steering supposed to have a slide joint in it?...
I routinely use my block heater in my Duramax in Houston during January/February for the comfort factor, and as I get older, that comfort factor...
Was troubleshooting the aftermarket tachometer which stopped reading and discovered that if the signal wire from the HEI distributor to the Tach...
Any of you install an engine block heater in your commando, specifically the :amc: AMC 304? I will admit, I live in Houston, and it doesn't get...
Anybody with a Parts Commando that has the original seat supports they feel like selling? A PO installed bucket seats in my 73, looking to...
There is currently one on ebay. jeepster commando switch panel all switches function jeep commando | eBay
No rubber pad between the axle and springs. The bushings are all new along with the springs, though they might need to be retorqued now that I've...
Locking Hubs, though I upgraded from the OEM to a Warn 27-spine, 5-bolt. Confirmed the hubs are engaging/disengaging just fine when installed by...
To you guys with lifted Jeeps, I'm still working the 73 Commando. This is the one with a [IMG] 304 that has a Holley 4160 mounted on the 2-barrel...
Not sure I could disconnect the fuel line that quick, even a minute is enough time for it to flood. I'm going to rip out the hose that was...
I have inspected, but cannot see fuel dripping from the venturies when I shut it down at operating temps. Light vapor will rise from the oil...
So, still picking away at the 73 Bullnose. Been chasing a ghost for the past month, pulled the carburetor off twice now. An earlier owner...
I'm working on rebuilding the E-Brakes on a 1973 Jeep Commando C104. This particular commando does NOT have the stock driveline, so I'm hoping...
After a busy day, I have confirmed both axles have a 3.07 ratio. Both have a 43 ring, and a 14 pinion The front D30 now has a tapped brass vent...
Thank you for the help. Another question, the Dana 300 (or typically all transfer cases) have a 1:1 output ratio between the front and rear...
Found the knuckle type, open knuckles.
As a 73 Commando, She should have a Dana 27, the 30 would be a change from factory. please expand on open vs closed knuckles, how do I tell by...
Separate names with a comma.