for TRW, I am seeing the following part numbers: Right Outer Tie Rod End: JTE1254 JTE1254 - TRW Automotive Aftermarket Parts Left Outer Tie Rod...
I am about to do the TRE flip on my 1960 and I have not yet ordered my parts. Have any recommendations? I have some of my initial thoughts over on...
I had a 6 foot long black rat snake crawl into the transformer out on the power line pole last fall -> Created a spectacular fireworks show. The...
Nice Jeep ... And Go Vikings!
I will likely do the Trackick for my next jeep!!! I also see that it is a smaller kit and clears the wheels a little better than the chevy K10...
I plan to do the tie rod flip. I already have a small shim in there and it doesn't do much to help the situation. The caster angles look correct....
Steering Knuckle Tie Rod Hole
Steering Box input shaft
Steering box and rods removed
Steering Knuckle Tie Rod Hole Bottom
Steering Knuckle Tie Rod Hole Top
I used Herm's kit. I almost bought a collection of parts to piece together myself, but I figured it was worth the extra cash for me to know that...
Those are nice!!! I might make a set for when I put the hinges back on!
Since I had it flipped upside down recently in good light; here is a picture of the the tailgate hinge area on my 1960 CJ6. I don't think this...
Tailgate Hinge re-enforcement?
After all this work, I had to call it quits for a while and pack everything back into the garage. I built a table from 2x4s to clear the frame and...
Next up is the front suspension. The springs, shocks, shackles and everything else bolted right on after we got the old bushings out. The wheels...
The Rear tank is a very - very - very - very - very tight fit. You can almost see some air in there if you squint with one eye closed. The skid...
Separate names with a comma.