I think I have a set from a 67 CJ5 I parted out. Later today I'll try to find them.
A Buick 231 Even Fire from late 70s up, as long as it came out of a rear wheel drive car would be the easiest swap, and they are plentiful. The...
Want to double your money?
X2 on what "Jeepdaddy2000" said. Put brakes and steering at the top of the list. Start with the brakes. This will likely be the most difficult...
Block would be the same for either, the camshaft and distributor would not.
Similar design purpose on a Jeep tank is served by the "cup" of the fuel drain. Water from condensation will settle in the cup, and opening the...
Never seen a marine version of the 225, but my first wife's uncle once installed a small block engine out of a twin screw cabin cruiser into his...
X2 on Ospho. I have been using Ospho for at least 30 years and it works without costing a lot.
With a hole in the pan there wasn't enough oil let to cool it down. When I divorced my 2nd wife I let her keep the two year old 92 Jeep Cherokee,...
Time for a new Timex :cry:
Don't know what year Jeep you have, but my 67 CJ5 heater has a Cable operated heat/vent control that works a flap in the heater box from either...
Being "rare" is not likely to mean more valuable because of parts availability. I don't think you would be able to sell any old one for enough to...
Advance Adaptors took over the OD production from Warn. As already mentioned, the shift forks are different as the Warns had a bronze fork and the...
I hardly ever use any RTV, and use the "Right Stuff" only in the corner joints of the oil pan gasket, and sometimes on transfer case /...
Not if you use Permatex #2
It is a wonder that we ever got by without Youtube prior to the interweb. :coffee: Pete is right. Slow leaks usually get worse, and when enough...
Might be able to loosen it with a crow foot.
A while back I needed to change the blades on my bush hog. Great big nuts torqued to 450 ft lbs. I bought a battery operated "Kobalt" branded...
Harbor Freight sells a Bauer corded impact wrench with 1050 Frt. Lbs. breakaway torque. I got one as a door prize at a Jeep event, and that baby...
Pete is correct, the only danger is leaving enough ridge for the top piston ring to catch on. First engine I ever overhauled I didn't own a ridge...
Separate names with a comma.