If I can pick you guys brains a little further. Trying to "clock" the wiper blades now that linkage is in and running smooth. I have heard/seen...
Nutserts drilled out surprisingly well, just like you would do to a rivet. I used some silicone to hold gasket in place which I think will be just...
Ok, so I got the kit from Barneys, very complete and nicely made. Before I installed I wanted to see if there was a better way to screw/hold the...
Thanks guys for the feedback. Aftermarket is hit and miss at best. I did order the kit from Barney and going to give it a try because it does come...
Having same problem as before where wipers will work just fine for about 4-5 cycles then bind to a complete stop. I have taken linkage apart,...
rejeep, not sure what or why you are saying "just so wrong as an across the board statement". I sure as heck don't care that WIX or any other...
To each his own, but AC delco filters are nothing more than re-packaged FRAM filters which are constantly being show their filtration/micron...
To date, Mann-Hummel is still making Napa Gold & Platinum filters. I was definitely having drain back issues with the Napa Gold 51258, not sure...
IMO, one of the best things noted was to get a coolant system pressure tester. Pump it up to 16psi and let it sit and see if it bleeds down. If...
It is as aftermarket/foreign as they come. It has always been a contention point when I purchased the Tub/Fenders/Windshield Frame from...
Bushings and everything else still look new. I took entire linkage back out to make sure arms were not bent and they were fine. I was able to...
Plastigauge is your friend. Don't guess while you have it this far down. Get the specs and check it with plastigauge. Napa or many other places...
After the restore, my windshield wipers worked fine on either speed and they self parked when I turned them off. Raining the other day, turned...
You come pick up or cover shipping on this stuff. I know shipping is expensive on some of this so it would be shipped from 84119 zip code. New...
Not my plan to run without a tank. I am only separating the compressor from the tank to get it down to smaller footprint.
Thanks for sharing that info. My compressor is ViAir 325, I believe it runs up to 200psi and shuts off and on at 90psi. It is mounted to a 2gallon...
Desertrunner, off topic but would like to see a few pics of your on board air install. Where you put compressor/tank etc.
I went with an ATV type thumb throttle which is spring loaded to return because I do not want a locking type cable holding throttle open. It is...
Fireball, I like that idea where you are "pulling" from front of carb instead of back. That would accomplish a better way where it would be...
The cable end with the threaded portion screws into the thumb throttle and that is not the problem. The other end where the very small end on the...
Separate names with a comma.