Thanks, got it figured out, got the right studs and pressed them in with a c clamp and socket. All good now...
Hi all, Reviving this thread for one more question, I am putting the spindles back on and I have a set of bolts with round heads / one flat side...
Oops, I meant the axle shaft u joints. Been a long day... Its a '72
Open knuckles. A real joy to get apart, I might add. You can see the needles from the bearings by the vise, they just fell right out. [ATTACH]
Yeah I could've missed it I guess... I'm not reusing the hub, as I 'm converting to disc brakes and that came with it's own hub, etc., so I really...
Not the spindle bearing, the actual tapered wheel bearing in the hub. I only had one on each side. I just found out about the spindle bearing...
Thanks for the reply, I'll make sure if I need to buy more grease it's the same. After I pulled the spindles out, I got a better look at them and...
Hi, I am working on upgrading to disc brakes and I have a couple questions for anyone that's worked on the wheel bearings before. Does the...
Thanks for the advice all, I got it all up and working again. I did accidentally cut into the hanger bracket a little with the saw but it's not...
Hi, thanks for the reply. Good idea on the ubolts, I actually had to go to a spring shop to get the bushings and they make ubolts, had them done...
Hi all, I have a question about the front shackle hanger bracket on my CJ5, when I had it in for an alignment a few weeks ago the guy said I...
Separate names with a comma.