The stuff seems to resist most any chemical very well. I'd say it's definitely worth a shot!!
This looks like it could work: http://eclecticproducts.com/downloads/tds-seal-all-english.pdf Seal-All Adhesive & Sealant Brake Fluid Resistant...
The new CK4 diesel oil isn't much different than any of the other automotive oils nowadays. If you're worried about your flat tappets, you would...
I use 3/4" copper water pipe beaten flat as a backer when filling holes. Doesn't last long, but it's fairly cheap, easy to find, and works well
I've been using this sander at work lately, and have been very happy with the results. The sanding discs are reasonable at the local lumberyard...
Got the engine compartment wiring finished: [IMG] And got the engine broke-in! It didn't fall apart, runs very well for no tuning, and is...
No offense, but I really, really, do not want to be in your club! Lol
The goes part is what scares me! This is the first engine I have ever re-built on my own. Fingers Crossed! It's really gonna hurt if I have to...
My jeep has R&P's 1/4 ton kit on a Dana 30. I'm running 33x10.50's, and I'm sure they'll be more than enough. I'm very happy with the fit/finish...
I'm actually not sure of the actual rope capacity, but the winch is rated at 9500lbs. I picked it up from desert rat. It had good reviews, so I...
Well, I haven't updated this much lately, but I have gotten a lot done on the jeep. Pedals are in, battery is mounted, seats are in. Front...
I sprayed mine with Tractor Supply paint too, with their hardener. Oliver green. Shine is decent, looking forward to seeing how it holds up:...
I installed R&P's kit as well. This is their 1/4 ton kit, which is slightly cheaper. Install was easy, and I'm very happy with the end product...
I was going to say tires too. I had a set of the 34x10.50 LTB's on a toyota about 8 years ago. They were great off road, but nearly unusable on...
On the rear of the block, it looks like you could move your temp sensor to the top of the head, and put the heater valve in it's place.
Looks great! I've got a brand new set of 33x10.50 bfg km2's on 15x7's on my build. I'd be happy to measure actual height tomorrow if it will...
Yes, I got my clutch and brake master cylinders mounted on the firewall, after building some custom plates to sandwich it. I also got my...
It's been too long to return them, so I ended up just trimming them to fit. I'll post some pics in my build thread later. Thanks for the help.
Got a lot done over the last couple of days. A week off work sure makes the project move quickly! I got the tub mostly reassembled, rear...
Try this thread: http://www.earlycj5.net/forums/showthread.php?80969-Steering-wheel-removal
Separate names with a comma.