I would appreciate some help in determining a reasonable value for what I have before I list it for sale (this is not a for sale ad and it is not...
I had to remove the factory drawbar setup from the 75 frame I used for my build because of my HD greasable shackles. I want to put it up for sale...
I am reassembling my frame brackets and I just realized that none of the donor Jeeps had the hardware that goes in the front gas tank mount (the S...
I am getting close to being able to install the gas tank. I think I am just going to buy a replacement steel one. I see 3 choices: Crown...
I have to temporarily assemble the front clip of my 74 cj6 so I can get it titled. The screws that hold the fenders to the grille are missing....
My jeep tub came with a nice pair of stock 75 CJ-6 low back bucket seats. They have the brackets still attached to them and they have no rips or...
Yesterday I used the pressure washer to strip the old crusty hard padding off the CJ-5 roll bar that came with one of the CJs I bought....
I am starting on repairing the rear of my fiberglass tub and I need to replace the original 74/75 filler neck the P.O. used as its rusted badly. I...
After a boiling hot summer and many months of illness I am finally ready to resume work on the 74 CJ6 build. I want to start with some work on the...
Yesterday I had to do some digging in the shed and had to move a bunch of the parts that came with my CJ6 when it was someone else's basket case....
Can someone with a 74 measure where your stock VIN tag location is? Like how far down and how far left of the seams on the cowl. I need to rivet...
I am starting to prep my fiberglass tub for refinishing. I have a oem roll bar that just sits on top of the wheelwells (I know this is not a...
Anyone on here ever adapt the 76+ Tuffy security glove box to the 75 or older dash? If so what was involved?
I have been reading through lots of posts and looking at lots of pics and I can't seem to figure out if a 74 CJ6 should have rear side marker...
I want to change the pinion seals in my 30 and 44. Timken offers 2 options for the seals. The 5778 and the 5778v. supposedly the same seal fits...
I want to completely rebuild my stock 74/75 dana 30 lockout hubs. I have searched around and have not found any instructions on how to tear them...
I am going to be buying greasable shackles and main eyes for my 74 CJ-6 pretty soon. I have read everything I can find on what is available for...
Sorry, yet another Dana 30 knuckle/disk brake question. I have both the 77 6 bolt brake knuckles and the 86 2 bolt brake knuckles. Can the...
Pretty soon I am going to finish my tear down so I can re-finsh my frame and assemble my rolling chassis. I want to replace my shackles and main...
Is there a difference between the 72/73 CJ front ends and the 74/75 CJ front ends? A question has come up regarding parts stores listing a...
Separate names with a comma.