New Clutch/Brake Pedal Damper Kit

I bought a damper kit for my 70 CJ5, but it appears I was sold one that is more appropriate for a 2a/b. the reason I am questioning it is because the outline of the originals are still on the floor boards. anyone have a picture of originals they could share.

 

I used a piece of inner tube and glued it to the floor with weather strip adhesive.

 

The CJs from just a couple years earlier consisted of a spring, fender washer, and rubber seal washer that mounted on the pedal arm under the floor. Your clutch pedal arm seems a little low, from the position of the original hole. You may want to see if you have wear on the clutch/brake crosstube where the pedals pivot.
-Donny

 

Thanks for the advice. I found an inner tube that I had laying around. Will also take a look at the cross tube.

 

Do you have a body lift? Something is causing an alignment issue.

 

My 70 has the same imprint. I thought it was a home made tape job over the hole. I had only seen the under floor like Donny mentioned.

 

no body lift. I took a look at the assembly and although on the loose side, nothing seems to be out of alignment.
The assembly could use a rebuilt kit, or at least to be taken apart and gone over.

ojgrsoi,
Yours looks like it has a washer on the underside of the floor board. To me it looks like a factory job, since both jeeps have the exact same imprint/double sided tape.

I ended up cutting an old inner tube and using some 3M spray adhesive. I will have to do some more looking around and hopefully can come up with a more accurate way of building/fabing a set.

 

I saw DJ Butler's under floor set up on our Rubicon trip last year. I picked one up from Walck's I believe.

 

Jeep Cj2 Cj3 Cj5 Cj6 M38A1 Mb 46-71 Pedal Draft Pads Kit X 16750.09 | eBay
This is what was originally used.

 

That's what I purchased for my CJ6. It didn't help.

Was I supposed to take them out if the box?


I have used black duct tape around the single stick on the transfer lever and that worked very well.

 

That's the one I got as well. But I think it's a generic kit and not the one used for later cj's like mine

I can use it on my '47 though so not a complete loss

 

Pardon my ignorance, but what are these things supposed to do?

I’ve looked at a lot of interior pics, you know, checking for authenticity in all details and have never noticed such items installed. Many thanks.

 

They do two things; they cover the gap around the hole in the floor where the pedal arms go through, and they provide a little cushion against the pedal slamming against the floor when released.

 

I just used a piece of 3/16 rubber on mine , it keeps the water from splashing up through hole . does look like it time for a new one

 

The outline you both see on the inside on the floor boards appears to be the self adhesive stick on factory pad.
More of a draft pad to cover the hole.
The p/n was 946728, measuring 2-1/2' by 3'.
I tried them on mine as well and they didn't last very long.