Hey all, I figured I should start a thread for the project at the back of the line, so I can at least post what I'm spitballing. Best I can tell, this is probably a mid to late 1959 B120. Looks like factory BD264 I6, T98, NP202 with duel gas tanks. Added Tulsa 800 PTO winch, power brakes and a funky set of tanks in the back. The bed is off a later C series International, which was widened to cover the rear dual wheels that were also added. There's an aftermarket AM radio in the dash, a pipe bolted to the front axle shifter, and the PTO engages from a little knob you pull in the floor. I'm planning to ditch the bed, which is falling apart at almost every conceivable area, and has been crushed in. It'll get a flatbed, an IH 345 V8, recored radiator, swapped axles so I can ditch the "big 6" bolt pattern for 8lug. Steering is a huge Ross box and parts are getting very expensive so that'll get ditched hopefully for ram assist steering. The bumper looks like it was made using the original bumper, and was totally trashed getting it onto the trailer when the PO bought it at auction. It'll need some work, but it'll be saved, maybe cut the center out for a winch fairlead. Originally, a hole was punched in the center of the bumper for the cable. Last night I went around and sprayed just about every part of the winch with penetrating oil, and starting hitting other small bolts. I completely forgot to spray the bolts for the bed, which was the whole reason for going out to the truck in the first place. Heres the pics to start it off.