Discussion in 'Early CJ-5 and CJ-6 Tech' started by kenb, Apr 13, 2019.
Detroit = Rust belt, we are on top of a Salt mine here in Detroit. We have drive lines, no bodies...
Bad case of "the Jeep lean"
I'm thinking next chance I have I'll pull the drain plug on the trans and see what comes out. Thinking about filling it with a penetrating oil just to see if that loosens anything. Any recommendations on what to put in?
It depends on what comes out of the drain plug. I would pull what is left of the floor plate and remove the six bolts retaining the top cane shift assembly. That way, you can look in and see the condition of the gears, and the oil, if any is left. When transmissions have flooded with water, I drain all I can, and refill with diesel fuel to hold off further rusting.
OK thanks, I'll try and have a look see that way. Per the previous owner it had a half cab on it until fairly recently so I'm hoping that helped protect it.
These exact pictures turned up yesterday on the abandoned_jeeps instagram page.
Check it out
Abandoned & Neglected Jeeps @abandoned_jeeps - Instagram Photos and Videos - #Yooying
If I knew it was going to be internet famous I would have taken photos from a more flattering angle.
Or in the dark with no flash
Love that second pic in the original post. You know it is bad when your side mounted spare actually reaches the ground on its own and helps hold up the vehicle like a training wheel.
Ive heard ATF works well to loosen rusted parts. Mixed with acetone is often mentioned, though I suppose the idea is to let the acetone flash off. That wont happen in a closed tranny, and you sure better not decide to use a torch on it until it does evaporate off.
I got it pretty well taken apart today. Guys were right, it does have 4.27 axles. All the shift levers are moving so that's a good sign. I squirted a lot of marvel mystery oil into the cylinders. Planning to gently try and turn the engine next week.
I believe you are now what the kids call an "influencer".
I hope that you have a well organised shop to separate parts and throw away the rusted parts. Rusted steel is like a razor and you can be hurt easily. I cut my leg long ago on a Citroen DS and felt nothing except I saw blood. Then I had to have some sewing at the hospital .
Can't you somehow make money by being an influencer? I must be doing it wrong.
Yes, I'm fortunate to have a good work space to dismantle this. I did however manage to light my pant leg on fire using the cutoff blade in my grinder today. Come to find out sparks are hot.
Modern fabrics in contact with grinder sparks melt. I have a big hole in the sleeve of a fleece pullover that was in the path of grinder sparks.
Something for your resume!
Looks just like the '56 I drove in college. I had a pair of wood 2x6 planks under the body holding it up.
That PTO is nothing to sneeze at. PTO winches are the bee's knees.
Cotton is the solution. Except specialised clothers using special fibers like Nomex, there is always a risk of melting, burning...
Separate names with a comma.