1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Dauntless Clutch Fork Installation

Discussion in 'Early CJ5 and CJ6 Tech' started by Strider380, Dec 18, 2018.

  1. Dec 18, 2018
    Strider380

    Strider380 Can I have a zip tie?

    New England
    Joined:
    Jan 12, 2006
    Messages:
    1,117
    Is it possible to grab the throw out bearing with the clutch fork... after the tranny and motor have been mated? I cant see in there. Gonna take anothe stab at it tomorrow with a better murror and better flashlight. Am i wasting my time? My clutch fork is in the bell housing, i just dont believe its in the correct groove of the throw out bearing
     
    Strider380, Dec 18, 2018
    #1
  2. Dec 18, 2018
    Twin2

    Twin2 not him 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Virginia Beach, VA
    Joined:
    Apr 28, 2011
    Messages:
    5,421
    you can see it with a mirror . but that's about it . if you installed it wrong on clutch fork . going to have to be pulled again
    dealing with throw out bearing and input shaft . is the reason I always install bell housing on transmission . then install as a unit
     
    Twin2, Dec 18, 2018
    #2
    cookieman likes this.
  3. Dec 18, 2018
    rejeep

    rejeep Well-Known Member 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Rochester, NY
    Joined:
    Nov 5, 2009
    Messages:
    1,691
    anything is possible..
    but you will have MUCH MUCH MUCH less frustration pulling the units..
     
    rejeep, Dec 18, 2018
    #3
New Posts