1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Lubing upper king pin bearing

Discussion in 'Early CJ5 and CJ6 Tech' started by Walt Couch, Jul 9, 2010.

  1. Jul 9, 2010
    Walt Couch

    Walt Couch sidehill Cordele, Ga. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    cordele, Ga.
    Joined:
    Mar 29, 2007
    Messages:
    5,922
    Was thinking of doing the zerk install, but then I got to thinking. :D I don't have any areas close by to do any 4 wheeling so I don't know how I would know if I am getting sufficient lube into the upper king pin bearing. So If I just lock in my front hubs and drive in 2 wd high, the fast spinning of the knuckle should throw the lube up into the bearing. RIGHT..and this would be true for both sides. YES?
     
    Walt Couch, Jul 9, 2010
    #1
  2. Jul 9, 2010
    Mcruff

    Mcruff Earlycj5 Machinist

    Albertville, AL
    Joined:
    Sep 22, 2002
    Messages:
    5,349
    This is exactly how the upper bearings were intended to be lubed.
     
    Last edited: Jul 9, 2010
    Mcruff, Jul 9, 2010
    #2
  3. Jul 9, 2010
    Walt Couch

    Walt Couch sidehill Cordele, Ga. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    cordele, Ga.
    Joined:
    Mar 29, 2007
    Messages:
    5,922
    Great.. I missed it if it is in the FSM and I did some searches also but couldn't find. Appreciate it Mike.
     
    Walt Couch, Jul 9, 2010
    #3
  4. Jul 9, 2010
    jasonjp62

    jasonjp62 Member

    Pennsboro WV.
    Joined:
    Aug 15, 2009
    Messages:
    799
    I always wondered! learned something new today. thanks guys
     
    jasonjp62, Jul 9, 2010
    #4
  5. Jul 9, 2010
    Patrick

    Patrick Super Moderator Staff Member

    Los Alamos, NM
    Joined:
    Sep 22, 2002
    Messages:
    8,360
    If they were packed upon installation, they don't require much anyhow. Low speed (extremely for a tapered roller) low heat environment.
     
    Patrick, Jul 9, 2010
    #5
  6. Jul 10, 2010
    jasonjp62

    jasonjp62 Member

    Pennsboro WV.
    Joined:
    Aug 15, 2009
    Messages:
    799
    I tore mine down today and repacked the bearings and new pudding in the knuckles. made it steer a little easier but not allot. the bearings looked like they were starting to get pretty dry. but they weren't shot.
     
    jasonjp62, Jul 10, 2010
    #6
New Posts