Offenhauser Intake Heater Hose?

Hello I have a new to me dauntless V6 with Offenhauser 360 intake. I am trying to hook up the cooling system but I have no idea where the old owner put the heater hose. My old hookup was on the rear of the stock intake. This intake has no ports except one in the front that is plugged off. Its slightly behind the thermostat housing and im sure connects to it. I assume it probably goes there but doesn’t seem right to me. I have researched the Offenhauser catalogs to no avail. Lots of offenhauser 360 intakes have ports all over but this only has that one single port. Any help would be much appreciated!!!

 

You'll have to t in your temp sender or get otherwise creative. The later versions have multiple ports.

 

I have that same intake. Rich M is correct. The outlet below the words dual port have my heater hose. Facing the front are 2. One for the temp sensor and the other for the thermostat bypass. Sounds like your plugged off one is for your heater hose. You do have to remove the coil to install / replace the temp sensor. I have a pic but it's too big to upload.

 

They loaded in reverse order. The top is a 360 equaflow while the bottom is a 360 dualport with no other water port options.

 

Mine is the dual port also

 

Thanks a lot everyone!