1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

setting 2g float level

Discussion in 'Early CJ5 and CJ6 Tech' started by cj6/442, Aug 17, 2013.

  1. Aug 17, 2013
    cj6/442

    cj6/442 Sponsor

    Fallbrook, Calif
    Joined:
    Feb 6, 2008
    Messages:
    2,734
    Today I'm working on a dauntless 2g .the balls were in the wrong holes and I have it all cleaned up now. I'm moving on to the float . the float dropout is pretty easy to fiqure out. I measured from airhorn to bottom edge of plastic float 1 7/8" . To set the dry setting my paper says 1 5/32 " but is unclear where to take that measurments. is that to top?
     
  2. Aug 17, 2013
    Walt Couch

    Walt Couch sidehill Cordele, Ga. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    cordele, Ga.
    Joined:
    Mar 29, 2007
    Messages:
    5,916
    Does your plastic float have a notch at the toe (small end)?
     
  3. Aug 17, 2013
    cj6/442

    cj6/442 Sponsor

    Fallbrook, Calif
    Joined:
    Feb 6, 2008
    Messages:
    2,734
    moving photo to bucket
     
  4. Aug 17, 2013
    cj6/442

    cj6/442 Sponsor

    Fallbrook, Calif
    Joined:
    Feb 6, 2008
    Messages:
    2,734
  5. Aug 17, 2013
    Warloch

    Warloch Did you say Flattie??? Staff Member

    Falcon, CO
    Joined:
    Mar 4, 2003
    Messages:
    5,466
    Float measure is from the top of the float to the bottom (or facing side) of the top plate on the carb.

    No - I am not gonna ask where your balls were :D
     
New Posts