It is important to insure that the rollbar is attached to the frame, not just to a rusty rotted section of the rear fenders. I rolled a 59...
Thanks for the pictures and the input guys. I have an extra Myers plow, which I can cut down to 48" wide and 12"high. I already have a home...
I'm thinking of building a small grader blade to go onto the front of my jeep. I have a myers plow, and can mount to that. My digger jeep...
T Vacuum setup only cost me $15 bucks. Electric conversion would have cost me near $100. Besides, vacuum tank benefits both wipers.
I use my jeep for snow plowing. I "upgraded" to a coil requiring a resistor, and have a "bypass" toggle switch to jump out the resistor when it...
The engine vacuum alone is a function of throttle plate position. At wide open throttle, the manifold vacuum can drop to zero, such as in...
Are you sure you have good fuel flow to the carb? Common for the fuel line to be plugged with rust or detached tank liner, which will allow some...
Just a though. When I first got my cj5 running after it has set for more than 20 years after an engine replacement, it would start and run when...
How about towing it backwards, tie down the steering wheel, put in 2 wheel drive. put the rear end on the tow dolly, transmission in park....
Roll bar- Yes, Seat Belts-yes. An use them, don't sit on them. See the following article, my son was in the back seat....
put some penetrating oil on the undeside of the bolt and then grind the exposed threads flush with the nut. The heat generated from grinding may...
Thanks for the link. Picked a heater motor up from Autozone for $20 last night. Great timing. I have to pull the seat ans swap the gas tank...
I have a 68, with 6,000 original miles. 1/2 top metal, also original. Heater in great shape, but last winter, the first I've used it to plow my...
I had an 81 CJ7 which I fixed up for my son to drive to school. I bought 2" spacers for front and back, which added to the stability on road and...
Separate names with a comma.
