At 5'9", I slump over the wheel to drive mine too. Just kind of the nature of the beast I guess.
I would love to check it out. You're quite a ways south of me, but I've never seen a Cerlist in person that I can recall. I hope you can get it...
I'm a little jealous to be honest... Have you made any progress on it yet? https://thefcconnection.com/mitchell_carter_fc-150.htm...
I went to a couple in Tacoma hosted by Gaylord. I can only recall one M677 being there the times I went and it was Steve's cause we went for a...
Which one did you go to John? Was it in Spanaway, Tacoma, Or Olympia? I've been to several, but definitely not all of them. There's typically not...
Should also have a full set of 11" drum brakes on it, centered flanged axle 44 and Dana 30 hubs and spindles. There's alot of useable parts on a...
I ordered a new motor and control pack form Warn. I bought the 15K industrial winch motor #70865 and a standard control pack for it. Back ordered...
I cleaned it up a bit this weekend and the motor is junk like I suspected. Now I just gotta weigh the costs of upgrading vs using what I have...
I think you're right duffer. I think the line speed does increase with the higher hp motor as well. I think I still have a 100' rope somewhere,...
I totally lucked out on this one. Usually all I end up with is cans too.... I suppose enough cans could be melted into a case for a winch?
Over the weekend, a guy I had purchased some Coleman stuff from several months back, messaged me asking if I wanted an old "Warn stand up winch"...
Separate names with a comma.
