1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

jeepdaddy2000's Recent Activity

  1. jeepdaddy2000 replied to the thread Speedometer Face Flipped..

    Install four 9" bolts in place of the dash mounting bolts Unbolt the steering column from the dash and pull it down slightly Pull the...

    Feb 18, 2025 at 11:32 PM

  2. jeepdaddy2000 attached a file to the thread What torque for shackle bolts?.

    The answer depends on your bushings. Stock elastomer bushing inner sleeves are designed to rotate with the shackle. They need to be...

    upload_2025-2-18_7-27-8.jpeg upload_2025-2-18_7-30-17.jpeg Feb 18, 2025 at 10:35 AM

  3. jeepdaddy2000 replied to the thread Irregular Pop At Exhaust.

    The instructions are generic for about 90% of all carbs. If your carb has air bleeds, then you may have to modify them.

    Feb 17, 2025 at 9:34 PM

  4. jeepdaddy2000 replied to the thread Irregular Pop At Exhaust.

    Absolutely. However, usually, unless there other parts of the "tune up" that are seriously off, getting to the point where the plates...

    Feb 17, 2025 at 11:56 AM

  5. jeepdaddy2000 replied to the thread 4.27 To 5.38 Skill Required.

    I've done a number of them, including my own. Regearing can be a hassle, especially with the Dana axles. Given the time and effort of...

    Feb 17, 2025 at 11:44 AM

  6. jeepdaddy2000 replied to the thread 4.27 To 5.38 Skill Required.

    Another option which may be easier is to install a truck 4 speed, either an SM series or T18. All three of these have a compound first...

    Feb 17, 2025 at 9:01 AM

  7. jeepdaddy2000 replied to the thread Irregular Pop At Exhaust.

    Idle mixture adjustment: Warm engine Rotate idle mix screw in (lean) till the engine RPM's drop Counting rotations, rotate out till...

    Feb 17, 2025 at 8:53 AM

  8. jeepdaddy2000 replied to the thread Dauntless Build Questions And An Update..

    If you put the two systems side by side, there is practically no difference between the two as far as additional loading. As I stated,...

    Feb 16, 2025 at 6:19 PM

  9. jeepdaddy2000 replied to the thread Dauntless Build Questions And An Update..

    The load never goes above a stock pump running the same bypass spring. The only added load is the "stock" load being lower in the RPM...

    Feb 16, 2025 at 1:04 PM

  10. jeepdaddy2000 attached a file to the thread Cheap Gl-4 At Tractor Supply Question.

    closed knuckle axles are notorious for leaking. A tried and true practice is to run a blend of 90wt and grease. This will thicken the...

    upload_2025-2-13_9-6-19.jpeg Feb 13, 2025 at 12:09 PM
Show older items
New Posts