I have searched and found the specs for the brackets that attach to the floor of the body tub but I haven't found anything as to the brackets that...
Does anyone have have the measurements for the rear seat brackets?
Does anyone know what spare tire carrier will fit my 74? The original body was replaced by the PO with an unknown year metal body bought from a...
Ahh....what a great idea....can't see the forest cause of the trees....Thanks
Does anyone have a source for the dhead bolt that attaches from the bellhousing of a T18 thru to the trans? Or a recommendation for modifiying an...
Hmmm. Not looking forward to pulling that heavy mess out again. I will go with a CV drive shaft, not sure what size lift to go with at this...
While checking the adjustment on my clutch linkage I found that the pivot ball mount on the bellhousing (74 CJ5-258/t18/d20) was broken. I must...
Two lines from the tank run to the liquid check valve (bottom ports). The top port on the LCV runs to one of the ports on the canister. One of...
I am in the process of installing a T-18 in my 74. I had to go with a different trans mount (R&P 4wd parts) and drilled the stabilizer mount...
I think I have it all together...it is a Jeep T18 w/ a input shaft from a 304/T150 combo. The Bellhousing is correct for my application per the...
Tim, (and fred) thanks for your help. No adaptor plate between the bellhousing and the trans I will call a vendor with the pilot/diameter and...
Separate names with a comma.