I just had this issue. I broke the brake line off at the combination valve and tried to get a socket on the fitting. Promptly rouded it off....
My steele brake line has developed a leak near the master cylinder. Is there a braided stainless option to replace the rigid bent steele? Thanks
Wow...I'm impressed. Great looking Jeep! Love my '75 best Jeep made. I may be a little prejudice though, had mine for over 30 years. I'd...
Have an Aussie in my '75 - love it.
Timgr - If you remove the inner seal, is it still necessary to grease the bearing or will the diff oil be sufficient? I just replaced my bearings...
Added by P.O. Is it a CB Mic clip? Or maybe just a clip to hold a piece of paper, like insurance card?
After mine sat for around 7 years, I cleaned it up - same as you're doing, change oil, replace gas tank, rebuild carb....ran great. The only...
Not interested in selling are you
Link should be www.jeep4x4center.com
Thanks guys....I've seen most of the write-ups. I was hoping to find some drawings with measurments, parts lists, etc. I'm not good at...
I'm looking for plans, drawings, measurments, etc. for a rear bumper with swing out tire carrier to fit my 1975. I've been searching the web...
I found a heavy rubber weather strip at a local truck stop - sold by the foot. I don't remember what it cost but much better than foam.
I've been in contact with Jerry at Rally Tops several times too. I hope he starts manufacturing tops for us intermediates. I can't change my...
Separate names with a comma.