I just added the full roll cage with the frame tie in kit from 4 wheel hardware. My fiberglass body is safe now.
I have just looked for the for sale forum......email me at jeeppaul@bellsouth.net......
I have the skid plate too
I have a 76 fuel tank that was in my 74 that I just replaced last night with a fuel cell......It has a leak around the vent tube but can be...
I used 3 degree shims to bring the pinion down and my jeep drives and tows much better
what year jeep did you put that t-176 in?
also I already had the pump, brackets, and steering box. I came up about 2 and a half inches on the hose.
went to hydraulic shop today. Due to the difference in the size of the fittings they could not do it. I found a race shop and bought parts to...
I have a 74 CJ5. I am adding power steering. Can someone tell me which pressure hose to buy. The one that I have is too short.
I installed new supertop this past January. I haven't been using my door upper halves because they don't fit. I have 4wd hardware fiberglass tub...
better make sure about the balancing....I installed a V8 in my jeep and was having the engine balancing done and took my I6 flywheel and the guy...
I run 33X13.50's on 10 inch X 2.5 backspaced rims and they do not rub anywhere.....I have flexed it very hard and bumped the back corner of the...
I have been away for the weekend.....Anyone have any ideas....I will try the Dodge ballast resistor on the module......The coil hasn't...
the link above does not work.....go to Google, type in amc ignition upgrade, it will take you directly to article I used to do my ignition system
Separate names with a comma.