All of the replacement panels that I have seen were sold without the channels. I have seen some nice fabbed floors and mounts using rectangular...
The plastic caps only plug the holes. The holes are for inserting the balls and springs, they are underneath the shift shafts. The springs and...
Yes, I checked the tech section, nothing there pertaining to mine, unless I did something wrong. All I found was for much earlier models and the...
Hi, Been a while since I have posted, New job has taken all my time. Has anyone got a copy of a wiring diagram for a 76 CJ5 that they could post...
You may want to be sure that your crossmember isn't switched end for end. IIRC there are some indentations that go to the rear on the pass side. I...
I have VIN sequence number 74488. My dash sticker was missing but from the build dates on other components I presume it to be built in June of 73....
The stuff you use before painting woks fairly well, Prep all or wax and grease remover. You should be able to get Prep all at Napa or wax and...
I looked in the parts book and it appears that in the intermediate years the T14 and T15 use the same bell housing(part # 321 5152). Also in the...
Jeeps are a lot like being married to some women; You have to work on them all week just to "enjoy" them a little on weekends. But on a serious...
There is a number of ways you can go and also some simple tricks. Dilectic silicon grease is a good way to go. But remember the earlier post in...
If you decide to put a patch plate/gusset on the side of the frame, don't make it a square plate, rather make it more "bullet shaped at each end....
I wonder if there is a source for silicon rubber gasket material that could be cut into strips and holes punched in it. I would think that would...
My 73 has stock Delco point dist. (no window, like the old Chevy 6 cyl cars) Points (Delco D108P) fit Jeep, Chevy and 70's Harley Davidson big twins.
They would of had the rectangular red marker lights on the sides. If you had a side mounted spare it would of had a round light in the center of...
Separate names with a comma.