I used a 76 and after on my 75. I think I had to drill an extra hole or two. Wasn't bad to install.
Drop me a PM. Just pulled some rubber ones of my 75 to install Xenon Extended units. We can talk.
I made my own for my 75 using a piece of Aluminum angle from Lowes and pull cables from 76 and after Jeep. Some of the cables are a little...
You may want to jack the rear up and check the wheels for play. Side to side and in and out. I had a bad/disintergrated bearing that allowed...
I recently replaced my fuel sender and it has the extra nipple for a return. I am currently running a single-in, single-out fuel filter which I...
After rebuilding my 75 I can say that's better then the norm....Attemp to disassemble the Spartan Assembly-Find screws heavily corroded-Attempt to...
No one to my knowledge makes them. You have to find a used one. I did so locally. Try this guy:...
I have a 75 CJ5 and am looking for the decal that is applied over the stamped Jeep Logo in front of the door openings on each side to make it more...
Thanks guys....Sounds like fabbing up a floor plate will be the biggest fabrication challenge. Would the stock bolt-in tunnel cover be found on...
Santa allowed me to "stumble" across a T18 Wide-Ratio/Dana 20 Combo with a bell housing for $350. It is out of a post 76 Jeep and was behind a...
I thought I asked this months ago, but cannot find it. I am trying to calculate the amount of lift I have between shackle reverseal, 76' Springs,...
Separate names with a comma.