High lift jack works great . I had the tough bead , try the front of the jeep if you run into it again . More weight from the engine makes...
Yes , it is true . I have swapped the high pressure fittings before . :)
Ist picture is a 1974 CJ Proportioning valve 2nd picture 1983 CJ prop valve . Font manual disc brake
Anybody know if a Alternator bracket off a 1980's 258 cui ,will work on the 1973 engine block for sure . OR is there a design...
I done a search and read all the threads on Power steering swaps . Still could not find a clear answer . Will a power steering pump/bracket...
To do the Chevy disc brake swap , you use the brackets from a mid 70 to late 70's Dana 44 axle . Chevy 1/2 ton truck K10 , Blazer etc... 4 x4....
What size engine do you have in your CJ5 ? If it is a V8 ,the smog pump mounts to the 304 360 V8 power steering pump bracket . On the bottom .
OK , thought I 'd see if someone had the same setup , so I could get a size . In case I run across some driveshafts before the swap....
Tranny is out of a 79 CJ7 6 cyl . I have the 2" rancho lift . The engine was removed from the jeep before I got to it , did find the...
Anyone have the T18 in a CJ5 , need to know what the length of the driveshafts are ? Front and rear , I have a 74 CJ5 304 . Are the 6...
Nice set up , I have the same on my 74 , except I did not throw the 4 barrel carb on yet . By the looks of your picture maybe I wont :)...
Pretty sure I had to make the slot longer in the bracket. This enabled the alt to swing up farther , for the mounting bolt to fit in the bracket...
Separate names with a comma.