-
Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.Dismiss Notice
FinoCJ's Recent Activity
-
FinoCJ replied to the thread 1970 Kaiser Jeep Cj5 And My Problem With Headers.
moved to proper forum....some pics would be helpful
Jul 7, 2025 at 6:26 PM -
FinoCJ liked Norcal69's post in the thread Engine Prep.
Do not turn the engine over! Remove the distributor and prime the engine oiling system, ensure the oil makes it to at least one rocker...
Jul 7, 2025 at 6:16 PM -
FinoCJ replied to the thread Dana 44 Skid Plate.
the 57 wagon is the same....thinking sway bar as its a pavement cruiser as much as a wheeler.
Jul 7, 2025 at 6:14 PM -
FinoCJ replied to the thread Wagon Sway Bar Retrofit.
no - but if you are only going to run one, especially on pavement, I think the front is best. You get the most body roll when turning...
Jul 7, 2025 at 1:42 PM -
FinoCJ replied to the thread Wagon Sway Bar Retrofit.
These arms are short (15") and have 2.5" offset - that might be pretty ideal: [IMG]
Jul 6, 2025 at 11:56 PM -
FinoCJ replied to the thread Wagon Sway Bar Retrofit.
yup....you are correct....before getting into details of how wide etc, I need to determine if I can even figure out a placement that...
Jul 6, 2025 at 11:51 PM -
FinoCJ liked wheelie's post in the thread Rims.
I got a guy on this. Trying to work out purchase and getting them here. Thanks for the tip Tim.
Jul 6, 2025 at 11:02 PM -
FinoCJ replied to the thread Engine Prep.
You can also make your own primer tool from an old sbc distributor.....pump oil through and then turn by hand a bit, pump oil and...
Jul 6, 2025 at 8:29 PM -
FinoCJ replied to the thread Wagon Sway Bar Retrofit.
Under the Addco options, they list 3 CJ Options: 71 and earlier, 72-86, and 76 and later. Looks like the primary difference is the size...
Jul 6, 2025 at 1:52 PM -
FinoCJ posted a new thread.
Wagon Sway Bar Retrofit
Been looking through some old threads on front sway bar installation.... (this one has some good pics:...
Forum: Builds and Fabricators Forum
Jul 6, 2025 at 1:35 PM