Its a fun project...while you're in there, consider converts from knuckle bolts to studs, there is a wealth of knowledge on this site for both the...
Is your shaft american made or over seas? There is a lot of variance in over seas made parts IMO, YMMV.
order one from krage $2.50, mght as well replace it with the real deal... :beer: www.jeepdoc.com/catalog/zproducts.asp?id=30 I'm sure he'll...
x2!!!
a wheel cylinder hone is sometimes called a brake cylinder hone, its just like a engine cylinder hone only smaller check it out, sears sells...
Update: Been in contact with Herm and he said that removal of the barrel nut will require a rebuild on the entire unit and the cost breakdown...
Hey Warloch, I take it you didnt damage anything else inside the OD using that square stock trick, did ya? I'd much rather get it out and send...
the snap ring and lock washer have been removed. to my understanding all that is left is the "barrel nut" which is stripped. it looks like...
that is the write-up I followed, but when I inserted the extension, it simply doesn't catch. therefore it's rounded (by the PO's dumb@$$.):mad:...
Here is what it looks like.
First a little background.... I scored enough parts (and cases) on craigslist to build 2 D18 and 3 T90 (for $40), the cases for the D18 are 1...
finished my rebuild today on my first t90! hooray! since this is my 1st auto rebuild attempt, i apologize that this question is so naive. i...
Fuggetaboutit = "Forget about it" You're good to leave it. :beer:
Separate names with a comma.
