I had seen some new purchases were $300-350 online. I'm not sure if I have a driveline shop in central michigan...you think I would but nothing...
1975 CJ5 - My front shaft is getting some slop around the splines... what options do I have for replacement? Can I buy a different year?
Ok, I put a new 401 in my 75CJ5, and the clutch engages at the very top of the pedal, and if I really get on it it will slip a bit. Do I want to...
At last, it lives! The only prob with this project was that Clevite77 sent me a rod bearing with two different sizes, and I slapped it all...
LOl, after doing some CSI tricks, I found a cast number in the rust. 3197219-C. With the casting number as 12:00, the weight is a 4:30. The wieght...
How do after market flywheels work for AMC? If the weight position is a guess for each engine, how do they mass produce?
Ok, that might solve my orientation problem, but I've searched the forum for a solid answer to counter weight position for identifiation, and cant...
I have yet to put a flywheel on, the motor is on a stand, and wont fit with a flywheel...are you saying the flywheels are drilled crank specific?
Take a look at the pic, I can see where the old hole was, but how does one know where that should go? I understand you can tell the difference...
OK, I was told this came out of a 77 wagoneer. Did they run 11" too?
How do you identify a 401 flywheel from a 304/360, and how do you know how to orient it? I would expect something to match the offset hole on the...
Separate names with a comma.