quadrajet carbs are famous for float bowl leak, during manufaturing port galley are drilled from underneath then solder up, after year the...
Back fires are mostly an ignition problems. you didnt say what ignition you have.sloppy throttle plates doesnt cause a sudden running problem,...
If you have a buick v6, I would check my valve covers first. They leak from the rear run down the back of the block and bellhousing and appear to...
Do you have full 12 volts to your petronics?
Check your valve cover gasket. If they are leaking, it runs down the back of the block and seems to be a rear seal leak.
That boot is mostly just a dust cover, but it seals the push rod and master cylinder so it some what hold the rod in place long enough to install...
check your dwell if you have points
Its about the points. Any more than 9 volts to the point will fry them. manufactures solve this with ballast resistors or resistor wires. 6 volt...
The grease and dowel method works better than any tool does. In my humble opinion:)
Moving vans move autombile all the time, Your probley authrized a certain weight if you dont go over your weight limt the driver will be glad for...
My head is spinning, lets see,generator vs alternator,9" brakes vs 11" brakes vs disc brakes.bias ply tires vs radial tires,stock head lights vs...
check your bulb and grounding and wiring on the right front, good luck
Soft or worn, loose or flexing body mounts?
Frame flex?
You changed the carburetor but did you change the base gasket? Each type carb has its own base gasket.
Separate names with a comma.