Thanks, I cleaned up the old one with some sandpaper. I think it will make due.
[IMG] [IMG]
Thanks for the pic! That’s the washer I’m talking about. The small end of my cluster gear has no notches for that washer. I think I’m going to...
i have just started to rebuild a T90 with a Novak kit. I just figured out that the small end of the cluster gear does not have the two keyways cut...
Swapped in the original capacitor last night. Still misfiring at idle, but it cleared up the rest of the RPM range pretty good. It's at least a...
Brand new, no ethanol.
Thanks I’ll look into this.
Clip was still in rotor, it was able to turn probably 10 degrees (5 each way) without the shaft moving points spring felt much better than the...
I also do not have a vacuum gauge yet. Can you recommend a decent one that won’t break the bank?
Yes it is 5BTC and mostly steady except for a rhythmic skip. I describe the shaft as slight as in perceptible but not loose or wobbly. The dwell...
Well first thing I found is that new rotor had a ton of play in it so I swapped to old rotor. No significant change. Twisting the rotor...
Thanks, I’ll swap the condenser and run theses test. I’ll let you know what I find out.
I did the 11s on the front at the end of last year. Huge improvements I still have 9s on the rear. I bought the kit from Herm’s to save time and...
Condenser was also replaced. Wires, coil, and plugs are new as of the end of last summer.
Separate names with a comma.