Thanks guys, no plastic tools were gonna get that thing off she was well stuck in there. Almost as if it was glued in. Out and replaced with the...
Well not so flat looks like a "hat" but probably rubber in the center of the steering wheel. Pretty much looks like this I'd suspect without...
My horn has stopped working. Doesn't move when pushed. Was working last I had checked until I needed it :) Is there a certain way to pull the...
I put an alum. rad on mine in the fall and it steamed and smoked. Had lots of trial and error with how tight to get the hose worm clips but...
Having rebuilt a couple Bosch K Jet metering heads, I call a spade a spade, the Carter is quite fiddly. :rofl: I'm sure it can be set up...
It ain't no Monobloc. :) lol of course the thing doesn't run very well with it. Back to the chinese solex
Okay so no need for the spring on the pointed Weight then? What about the springs. Have two the same length. Do they both go on the top of the...
So I finally got around to rebuilding the original carb a yf938 yesterday but have two questions as it has been a while since I disassembled and...
So I have it running quite well at the moment (not well enough to trust it for anything more than around the block) as pretty sure the distributor...
So can't get the video up but exactly how much play should there be when you turn the distributor rotor from side to side? Got probably 20...
Thanks, clutch is long since sorted and holding nicely. While I'm not doubting ya on the solex here is what doesn't make sense to me. The first...
Still missing something. While it starts right up and idles nicely on when you press the accelerator pump you get some hesitation and it has very...
So engine is in and running. Had to pull it out again as I used the flywheel and clutch out of the engine and the flywheel was about 1/4 inch...
Separate names with a comma.
