Well I think I got it figured out.i just needed to tighten it down more and it pulled the gap in. Ended up taking 4 shims to get a good preload....
I added the studs. i did mark the caps but it's possible I mixed them up at some point during cleaning. i was under the impression that they are...
I'll mess with some more later today and take some pics. I did use the correct timkin bearings and races. It's possible I have the caps installed...
I did test fit them first and they slipped on fine and seated all the way. I also tried a different cap on the top and got the same gap.
Yeah it's definitely a Dana 27 it's stamped on the pumpkin. I test fit the bearings on the caps and they slide on easily by hand. I guess at this...
I haven't quite got to that point. i have stacks of old shims and a new pack. I threw about ten random shims in to start off and it wasn't enough...
Hello all. I'm installing a new set of knuckles and bearings and it seems like it's taking too many shims. Something like a quarter inch. I...
Hello all! I have a few questions I can't seem to find the information for. Seems like the 11 inch brake question has been hammered out but it's...
Separate names with a comma.