That paint is way too nice for an inner fender. It will be a shame to close the hood
How do you run the vacuum advance? Does it advance at idle? Late timing exposes more of the cylinder wall to the heat of combustion.
This is a D20 output shaft. You can see the tapered roller bearings and the shims to adjust the clearance. [img]
Less dramatic but sometimes you can just drive it around with the pedal depressed. It just might let go peacefully :)
Are these drag start? Or do they have a pilot arc? I've used millers and a hypertherm that I think are pilot arc.
I'm not sure how much difference there is in reaction time between electrical and mechanical. I do know my electrical oil pressure gauge drops to...
All the concerns about leaks are why I like an electrical gauge with a sender on the engine. Stewart Warner is quality stuff and was the OEM for...
If they were designed like a modern vehicle I don't know that I would want one anymore.
The old shifter detent spring were broken and I replaced with new ones from the kit. I'm kind of surprised that the pressure needed to move the...
I like those rims. Didn't realize Ford had made a stamped steel rim in 15x8. I have 15x6 Ford rims on my jeep and they are a little narrow for...
The big spur gears are 1/4-3/8 larger OD than the originals. Even with some grinding that's about all that will fit it the case. I think the...
The new gears definitely have less helix than the old ones. There might be barely noticeable noise from them in 2 HI but you have to really listen...
Yes being straight through in high range makes it quiet. In low I've never been bothered by the low moan of the old gears or any other gear whine...
Separate names with a comma.