Fireball- do you know if the Yukon Gear YHC 50002 drive flange kit would work with this setup? Mike
Here are some photos [ATTACH] [ATTACH] [ATTACH] [ATTACH]
I could post a photos but I just talked with Warn and they said those were custom made for this application
I was looking at picking up a used full floating rear axle kit for a 1974 Dana 44 CJ5 axle. The problem is one of the wheel hubs is bent beyond...
Right- I just got a set from Benz Spring and there was a problem with the bushings in the eye. There is a short end of the spring, which is the...
So just like in the instructions above, you can see the center bolt is offset towards the outboard or bumper side and that would have the shackles...
For anybody that is running Holbrook springs I have a question. I am working with Benz springs on a set however they sent me a set that are the...
These are Crown Automotive and are 3 1/4 inches long. Regular bolts would lose the ability to grease them for the bronze bushing.
do you know of a source for the correct bolts?
I am putting on new leaf springs on my CJ3B , they are 1.75 inches wide. I bought new pivot bolts but the are a little longer than stock. It...
I am picking up a set from Benz Spring Co in Oregon next week. It is there model HJS-3F and HJS-3R they retail for about $200 a spring. You will...
Do I need a set up bearing for the outer Pinion bearing (nearest the yoke) or does that bearing slide on without being pressed on? Mike
I bought an empty dana 44 housing that I will be putting 4.56 gears into. The inner pinion bearing race was still in place and I removed it an it...
Separate names with a comma.