I was looking thru a pile of parts I have and came across a nos CJ3A or early 3B drivers side tail light. It is in the original Willys box with...
Does anyone have a source for FC-170 front wheel well mouldings?
A quick update. I rechecked the caster and it was at 7.25 degrees positive. Replaced the shackles with stock early CJ5 style, set toe in to 1/16...
Toe in is at 1/16", steering box is tight on the mount, The tires have been re balanced today, I replaced the extended shackles with stock CJ5...
I making the 2 front tires in today to get rebalanced to see if that makes any difference
ITLKSEZ- what would you like pictures of? As for balancing it was done by discount tire on their latest equipment.
Toe- in is set to 1/8 inch, all shackles are tight, there is no track bar on this unit. It worked well when I had a Dana 30 under it, but it had...
I have a 1954 Willys CJ3B with an LS1 style motor and turbo 350 transmission. The front end is a custom built Dana 44 with 4:56 gears and an Eaton...
Were these the Yukon YHC 70005 hubs or the drive flanges thru Amazon?
The Yukon YHC50005 is a great hub for the Warn full floating axle. It defaults to fully engaged if it should fail on the trail, so you can still...
It really became a problem a few years ago when I added an aux oil cooler, I guess the added fluid just needed a place to go.
What I found was that someone had connected the vent t5ube to the Dana 300 vent tube so that neither one could bleed off pressure against the...
Separate names with a comma.