So is this only true if the 4:1 jeep vs Ford? Does the 6.32 ford input swap into a jeep unit require 3rd gear replacement?
Nick suggested with the 4:1, it's more than just synchro and blocking ring....although if the comma after 3rd gear was a typo, it reads...
Seems as though it is....but these 'short' 4:1 input shafts are only Ford, thus meshing that into the remaining jeep gears requires some...
I was thinking Scott.....STL is a bit out of his way, and he'd have to do it in both directions
Obviously It's not the ratio that is the issue, but rather the input shaft length....I assume with 1/2 spacer and typical GM bell depth, this is a...
They've been out of stock for almost 2 years....but I've never talked to him directly about it. AA has this supposedly 23t short input shaft, but...
As I documented before...the 'jeep' 4:1 T18 I have has the 9" stickout that was used with the OEM iron adapter to AMC straight six engines, and...
This is one of those I may have one available in a bit. I am working on swapping out the OEM 10" brakes that would have the piece you need. It may...
Separate names with a comma.