1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

New 2 1/2" Lift Kit

Discussion in 'Early CJ5 and CJ6 Tech' started by Kevin D, Apr 9, 2009.

  1. Kevin D

    Kevin D New Member

    Just received my new Pro Comp lift today. I checked through the kit and noticed there was no transfer case drop hardware. I thought it would have come with that. It does have shims for the rear axle. Anyone running a 2.%" lift without lowering the transger case?
     
    Kevin D, Apr 9, 2009
    #1
  2. Patrick

    Patrick Super Moderator Staff Member

    Yes, I know of quite a few, myself included.... No problems..
     
    Patrick, Apr 9, 2009
    #2
  3. Patrick

    Patrick Super Moderator Staff Member

    In fact, my cross member is slightly higher than stock, and with the T18, my rear driveshaft is only ~12" long..No vibes.
     
    Patrick, Apr 9, 2009
    #3
  4. Kevin D

    Kevin D New Member

    Thanks. We'll see how it goes on my rig.
     
    Kevin D, Apr 9, 2009
    #4
  5. Patrick

    Patrick Super Moderator Staff Member

    I assume you Jeep is an early (since you're in this section). All you need to lower the crossmember is some 1/4" plates (that's what was factory) or the like, and some longer bolts. If you decide you want to lower the transfer case.
     
    Patrick, Apr 9, 2009
    #5
  6. blevisay

    blevisay Oh Noooooooooooooooo! Staff Member

    No drop here
     
    blevisay, Apr 9, 2009
    #6
  7. BDL67

    BDL67 Brad79

    I also have a 2.5 " lift (superlift) with no probs.
     
    BDL67, Apr 12, 2009
    #7