The bearing is made by SKF: SKF Explorer 6208 2RSNRJEM it also says 72-Made in USA 12 341 C I purchased mine through Carquest
On a F-134 can you remove the pistons from the bottom after you remove the crank ???
Can you remove the front main bearing through the front of the case or is it pressed on the main shaft ???
Is the front bearing (closest to clutch) on a T-90 removable from the front ? I am going to try the sealed bearing trick and didn't know if I...
From reading in "search" I see that a t-90 holds 2.5 pints and the transfer case holds 3.5 pints. If these units "share fluid" can I remove the...
I have been searching but have not located the answer I am looking for. I have a leak from the T-90 transmission front input shaft near the...
I have been searching the old posts but am still confused. Do I need to install a Balast Resistor if I am using a coil with an internal resistor?...
I replaced my 5-38 rear end with a 4-11 because I discovered my front end was a 4-11. I discovered this when I put it in 4 wheel drive. I have...
I am attempting to install the shoes on the rear axle. It appears these shoes require that "T" piece that fits into the shoe then goes into the...
I believe my 1962 CJ-5 has different gear ratios under it. The rear axle is a Dana 44 with these numbers: A 18419 43-8 5.38 U.S. Pat....
Does anybody have the NAPA part # for a rope rear main seal. I have tried two of the rubber ones and it just cuts them in half. Is there a secret...
Separate names with a comma.