IMG]http://i1099.photobucket.com/albums/g396/CleanCarShop/330180_2392014398535_1196155738_32924067_4031193_o.jpg[/IMG
I bought two 3 1/2 inch speakers and mounted them in 4 inch PVC end caps, drilled a hole for the wires painted the PVC with SEM plastic paint...
[IMG][IMG]http://i1099.photobucket.com/albums/g396/CleanCarShop/330180_2392014398535_1196155738_32924067_4031193_o.jpg[/IMG
http://s1099.photobucket.com/albums/g396/CleanCarShop/?albumview=slideshow 95% done...still have to fit the full soft top...do some painting of...
Has anyone used the old Spartan switch with the modern wiring harness from Painless? I can not seem to make it work.
Currently working on a 64...do you have pics? there is almost always more rust than you think...pics would be good for the forum to see what you...
I have R&P's Disc brake conversion front and rear...laid out on the floor of my shop...No instructions...Sunday no tech support...anyone have...
well, i got it off...used the proper 3 jaw puller bolted to the lugs....tightened with air impact...heated with torch, put a 3 ft pipe on the...
Actually that is what i did, thanks for the replies...I will let you know how it goes and hopefully have pics of the new discs on all four corners...
been doing that...does it help to leave the puller just snug and then hit? I have been bottoming the puller out then smacking after smacking i...
I just spent all day on one rear axle hub...I have the correct puller type. three jaws pulling on the lug studs/nuts. using an impact to get it...
Ordered new leaf springs from General Spring...softer 5 leaf at all four corners. three springs arrived in three days...fourth one made it half...
Thanks...I have also read that there is no point in using harder stronger bolts in some applications...my experince and common sense tells me to...
When rebuilding one of these things...Are there certain applications where the old fasteners can be re used? I can certainly see places that I...
As for when to sand and polish...I would read the label on the can of clear or the info sheet if given. Also contact your paint supplier for this...
A few tips on sanding and polishing clear...from a detailer. first start on the easy flat parts as suggested the hood would be a good place to...
Thinking about cutting the marker light indent out of new replacment fenders and replacing the section with those from old non indent fenders?...
Had this problem while painting a boat...we cleaned everything and bought those disposable in line filters...did you use a preps all type...
ditto looks right as compared to the 134 t-90 in the one I am working on.
http://s1099.photobucket.com/albums/g396/CleanCarShop/ I think it may have just taken me longer to upload photos of this rear corner repair,...
Separate names with a comma.