Here's another similar write-up. If the link doesn't take you to page 6 of the thread skip to that ......
So is there a measurement that I can take to insure I have the correct case for a lower gear set? The new ring gear I bought is definitely...
Can someone explain how to tell the difference in carriers? I recently bought one and was told it was for the lower ratios. But when I set it...
I tried disconnecting the rear driveshaft and running through the gears. It seems like if there isn't a load on the transmission it does okay....
If the "mainshaft rollers" are the bearings on the front of the transmission then yes I was careful to insure those were there properly. Many...
Nope, transmission did not get taken apart. I disconnected it from the t-case but I did not disassemble it.
I went out and checked the forks. They are in the correct grooves. There is some wear on the back of the forks but it doesn't looks too severe....
I have driven the jeep. Just up and down the alley and around the block but I am able to go through all 3 gears. When driving I can upshift but...
Okay, I need some help/advice/suggestions. I finally got my jeep up and running after several years in the garage. Unfortunately I am now having...
I recently found another L-head to replace the one in my jeep. As I started looking at it I noticed some differences in the oil lines to the...
I thought I might try to drive out there and take a look sometime in the next few days.
Is this sitting on 377 in Collinsville?
...so where is this $3500 jeep located?
So am I right in the thought that you can't swap "some" of the T98 parts with T18 parts? This is an all or nothing proposition correct?
Okay, I've been reading through old threads all day and I still have a few questions that I wanted to get confirmation on. I've found a T98 with...
That is what I plan/hope to do. I've been keeping an eye out for some for sale. I found a pair for sale but now I want to make sure that I'm...
Does someone have the length of the axle shafts for a Dana 25? Also will the axle shafts for a Dana 27 fit in a 25. Seems like somewhere I heard...
Doesn't the A1 also have the shackle on the rear of the front springs?
After reading another topic I wanted to ask for some opinions. I am putting in Saginaw steering with a DJ column. How do most of you supprt the...
I'm always looking for a good deal. Do you have any photos? What do you want for 1 of them?
Separate names with a comma.