How do you go about tightening up the steering on a 3B? All of the steering components look good but there is too much play in the wheel. Thanks
http://www.film.queensu.ca/CJ3B/Photos/Owners/Lachasse65/Lachasse65DashPlate.JPG
I was looking for a replacement dash plate and some original stickers and I remember that Walcks4wd used to carry them. I cannot get their website...
I just picked up a back seat for my 3B. It didn't have a back seat so I don't know how it mounts. Does anybody have any pics on how to install it?...
Some years ago, I purchased a metal reproduction plate on the dash that has the gear position layout and the transfer case and high/low range...
Thanks for all of the feedback on the following thread: http://www.earlycj5.com/forums/showthread.php?t=30001 I am going to pick up the CJ3B...
I am looking at a 58 CJ3B and was wondering about it's value. It is in good condition, starts and runs great. Everything seems to work fine. Also...
I have found a 46 CJ2A that I would like to pick up and restore. My question is, how many of the mechanical components will swap over from my CJ5...
Ok, time to make the big decision. To what level do I restore this Jeep? Do I go anal with it (like I usually do) or do I take it to a level where...
Who has the best deals on wiring harnesses? Need a complete one for my 64. Started to save it and decided If I am doing a frame-off why put back...
Thought I would use POR15 on my frame. Have had several people recommend it. Anybody here used it before? Any pointers or words of wisdom will be...
Well, I decided to get off my lazy butt and finish pulling the tub. Don't know why I procrastinated so long but now it is done. Frame looks real...
I was wondering how hard is it to install an M38A1 tub on my 64 CJ5? Any major frame mods required? Are the CJ grill and fenders the same? My tub...
Separate names with a comma.