Thanks, I didn't buy a kit, I bought the pressure plate and disc at NAPA years ago. This project got started and then put on hold for a divorce...
Does anyone know of a good source / part number for a clutch alignment tool for a T14 - 225? I don't have an extra input shaft. Any ideas will...
Thank you, we thought it would but wanted to check.
Will the adapter on a two piece bell housing from a T86 bolt up to a T14 or will the adapter need to be replaced?
I don't need a flywheel, only the bell housing. I have talked to another person with a bell housing in your part of the country, I believe...
Very helpful guys. sounds like the BDS route will most be the way I will go.
Thanks for the replies. I looked at the website; good write up and looks like a nice kit. I had decided to go with the BDS 2.5' lift spring kit...
I assume this has been covered before, but I couldn't find it in a thread search. What mods are required for an ECJ5 ('71) conversion to YJ...
Thank you
I have a 1971 CJ5 with a 225 and a T14. The transmission is out and over the years the bell housing has gotten lost. I've found one on the...
How about some small safety pins; I use them to push through a wire as a test point for my meter.
Several years ago I put my '64 CJ5 on the back of a GMC 3/4 ton with a regular bed (it actually fit in the back). I test drove it and that was...
Chris, was that new or reman stuff? I got reman'd (Jeep fund is gettin low) from NAPA and spent around $170, with no core charge.
I just picked up a pressure plate, clutch disc and throw out bearing from NAPA, I got the pilot bushing in today from Krage. NAPA has a complete...
Different shop. I live in Frankfort; about 50 miles from Louisville. I asked at the local 4X4 shop trying to support the local businesses. The...
I have a distributer in Louisville that can get the kit (BDS supplied the name). I just don't have any experience to guage the choice on. I really...
Sorry to bring this up again guys; I know there's been alot of threads on this (I've read them all). I had settled on buying a BDS 2.5" suspension...
If my memory is right I believe the spec is 0.004 - 0.008" with 0.006 prefered. It's real easy to set once you get the dial indicator set up. If...
Last fall I saw a guy out at Natural Bridge wheelin with an M38; he'd swapped the air fliter for a K&N type and mounted it with a Rubbermaid...
Jim, That's what I made these ones to.
Separate names with a comma.