Hi all Some progress on the XJ. I made a ACAD drawing of some rock sliders I wanted, I had them built and tonight was the install. Now they are...
Hi all I finally decided a color for the jeep. Until this morning I was going to go with a regular white for the body, and gloss black for the...
Hi all This is the time for something I did not do on the CJ yet. This is going to be a big project, very hard.... [IMG] Not really. In...
Hi I'm looking for a bearing to replace the one in my tranny. It is a MRC #308SG7, 1.5748 ID, 3.5433 OD, 0.7874 thickness, with snap ring....
Hi all I did drain the oil in the tranny. Along with the usual (I guess) small metal parts made by myself grinding teeth when I shift in 3rd, I...
Namely, a T-18A ? I checked the oil in the tranny, and there is some small copper particule, so I know some syncro are not in their best shape. So...
Hi all I can buy a stock roll-bar out of a 76 CJ. I would like to adapt it to make a front hoop that will attach to the usual dash location...
Hi all I had some problem with the jeep lately. I sprayed the carb with carb cleaner, I opened up the choke plate (by rotating the dial) a...
Hi all My CJ-5 spent most of the winter outside in my driveway. I drove it twice this winter. Last week I started it and it started, but after...
Hi Since i installed my T-18A, I had to put some angled pad on the axle to rotate the pinion. That dropped the actual height of my jeep. Now I...
Quick question this morning. I blasted my windshield frame and glass this weekend on the trail. Did anyone here put a YJ windshield frame on a CJ...
Hi all Quick question this morning. I will leave my jeep all winter to my dad-in-law place. During the deer-hunting season, we will take the...
Hi I was measuring the CJ-5 and the YJ last night, and if i remove 10 inches of the back of the YJ hardtop, I could make one for the CJ-5....
Ok, here it goes... When I replugged the new ignition box on my CJ, I tought I was plugged on the good wire....read on Last night, my...
I hope everyone here is doing well, because I'm not. We changed the timing chain, because we tought it was my problem. It was not, but we changed...
Hi all I went to put gas in the CJ after my gas tank skid plate swap this afternoon. The engine was running great, no apparent problem. In my...
Hi I want a tie-rod with tie-rod end for a trail spare. A guy has one from a 68 CJ-5. Will that fit my 77 CJ-5 dana 30 ? Thanks Bob
Hi all I will have my new gas tank skid plate tomorrow. It will be done in 3/16 think sheet metal. How do you suggest I finish the inside...
Hi all I've been working on this all winter, and it is finally over. I installed a 1983 Inline 6, a T-18A, a EZ locker and Yukon one piece axle...
Hi all Like an idiot I lost the measurement of both of my driveshafts that I took on the jeep before my tranny swap. Now I have them on the...
Separate names with a comma.